Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

getremoteservicesstatus

Table 1. Details of getremoteservicesstatusThe following table provides details about the getremoteservicesstatus subcommand:
getremoteservicesstatus
Description Displays the status of a system.
Synopsis racadm getremoteservicesstatus
Input racadm getremoteservicesstatus
Possible values for the host system status
  • Powered Off
  • In POST
  • Out of POST
  • Collecting System Inventory
  • Automated Task Execution
  • Lifecycle Controller Unified Server Configurator
  • Server has halted at F1/F2 error prompt because of a POST error
  • Server has halted at F1/F2/F11 prompt because there are no bootable devices available
  • Server has entered F2 setup menu
  • Server has entered F11 Boot Manager menu
Possible values for the for Lifecycle controller(LC) status
  • Ready
  • Not Initialized
  • Reloading data
  • Disabled
  • In Recovery
  • In Use
Possible values for the real time status
  • Ready
  • Not ready
  • Not Applicable
    NOTE:The real time status is displayed as Not Applicable if there are no real time capable controllers present on the system.
Possible values for the overall status
  • Ready
  • Not ready
Possible values for the Telemetry status
  • Ready
  • Not ready
Example 
  • racadm getremoteservicesstatus

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\