Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

gettracelog

Table 1. Details of gettracelogThe following table provides details about the gettracelog subcommand:
gettracelog
Description Lists all the trace login entries of iDRAC.
Synopsis 
  • racadm gettracelog [-i]
  • racadm gettracelog [-s <start>] [-c <count>]
Input
  • —i — Displays the number of entries in iDRAC trace log.
  • -c — Specifies the number of records to display.
  • -s — Specifies the starting record to display.
Output The default output display shows the record number, timestamp, source and description. The timestamp begins at midnight, January 1 and increases until the system starts. After the system starts, the system’s timestamp is used.
Example
  • Display entire log 
    racadm gettracelog
  • Display number of records in log 
    racadm gettracelog -i

    Total Records: 228

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\