Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

ifconfig

Table 1. Details of ifconfigThe following table provides details about the ifconfig subcommand:
ifconfig
Description Displays the contents of the network interface table. To use this subcommand, you must have the Execute Diagnostic Commands permission.
Synopsis 
racadm ifconfig
Input N/A
Table 2. Example 
$ racadm ifconfig
Example 
eth0 
 Link encap:Ethernet  HWaddr 00:1D:09:FF:DA:23
 inet addr:192.168.0.0 Bcast:192.168.0.255 Mask:255.255.255.0
 UP BROADCAST RUNNING MULTICAST  MTU:1500 Metric:1
 RX packets:2550665 errors:0 dropped:0 overruns:0 frame:0
 TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
 collisions:0 txqueuelen:1000
 RX bytes:272532097 (259.9 MiB)  TX bytes:0 (0.0 B)

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\