Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

ping6

Table 1. Details of ping6The following table provides details about the ping6 subcommand:
ping6
Description Verifies if the destination IPv6 address is reachable from iDRAC or with the current routing-table contents. A destination IPv6 address is required. Based on the current routing-table contents, an ICMP echo packet is sent to the destination IPv6 address. To run this subcommand, you must have Debug privilege.
Synopsis 
racadm ping6 <ipv6address>
Input <ipv6address> — the IPv6 address of the remote endpoint to ping.
Example 
Pinging 2011:de11:bdc:194::31 from 2011:de11:bdc:194::101 with 32 bytes of data:
Reply from 2011:de11:bdc:194::31: time<1ms 
Reply from 2011:de11:bdc:194::31: time<1ms 
Reply from 2011:de11:bdc:194::31: time<1ms 
Reply from 2011:de11:bdc:194::31: time<1ms 

Ping statistics for 2011:de11:bdc:194::31:
    Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
    Minimum = 0ms, Maximum = 0ms, Average = 0ms

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\