Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

racreset

Table 1. Details of racresetThe following table provides details about the racreset subcommand:
racreset
Description Resets iDRAC. The reset event is logged in the iDRAC log. To run this subcommand, you must have the Configure iDRAC permission and configure user privilege.
NOTE:After you run the racreset subcommand, iDRAC may require up to two minutes to return to a usable state.
NOTE: You can run racadm racreset --wait command using local RACADM.
Synopsis 
racadm racreset
Input
  • Not applicable.
Example
  • iDRAC reset 
     racadm racreset

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\