Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

testalert

Table 1. Details of testalertThe following table provides details about the testalert subcommand:
testalert
Description Tests FQDN supported SNMP trap notifications. To run this subcommand, you must have the Test Alert User Access.
Synopsis 
racadm testalert -i <index>
Input -i — Specifies the index of the trap test. index must be an integer from 1 to 8 on iDRAC.
Output 
Success: Test trap sent successfully
Failure: Unable to send test trap
Example
  • Test a trap with index as 1. 
     racadm testalert -i 1
    Test trap sent successfully.
  • Test a trap that has not been configured yet. 
    racadm testalert -i 2
    ERROR: Trap at specified index is not currently enabled.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\