Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

testtrap

Table 1. Details of testtrapThe following table provides details about the testtrap subcommand:
testtrap
Description Tests the RAC’s SNMP trap alerting feature by sending a test trap from iDRAC to a specified destination trap listener on the network. To run this subcommand, you must have the Test Alert permission.
NOTE:
  • Before you run the testtrap subcommand, make sure that the specified index in the RACADM iDRAC.SNMPAlert group is configured properly.
  • The indices of testtrap subcommand is co-related to the indices of iDRAC.SNMPAlert group.
Synopsis 
racadm testtrap -i <index>
Input -i <index> — Specifies the index of the trap configuration that must be used for the test. Valid values are from 1 to 4.
Example
  • Enable the alert. 
    racadm set idrac.emailalert.1.CustomMsg 1
racadm set iDRAC.SNMPAlert.1.State 1
  • Set the destination email IP address. 
    racadm set iDRAC.SNMPAlert.1.Destination 
192.168.0
  • View the current test trap settings. 
    racadm get iDRAC.SNMPAlert.<index>
    where <index> is a number from 1 to 8

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\