Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

traceroute

Table 1. Details of tracerouteThe following table provides details about the traceroute subcommand:
traceroute
Description Traces network path of the routers as the packets traverse from the system to a destination IPv4 address. To run this subcommand, you must have the Execute Diagnostic Commands permission.
Synopsis 
racadm traceroute <IPv4 address>
Input IPv4 — Specifies IPv4 address.
Output 
traceroute to 192.168.0.1 (192.168.0.1), 30 hops max, 40 byte packets
1 192.168.0.1 (192.168.0.1) 0.801 ms 0.246 ms 0.253 ms

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\