Integrated Dell Remote Access Controller 9 RACADM CLI Guide

Using autocomplete feature

Use the autocomplete feature in firmware RACADM to:

• Display all the available RACADM commands in the alphabetical order by pressing the tab key at the racadm>> prompt.
• View the complete list, by entering the starting letter of the command at the racadm>> prompt and press tab key.
  NOTE:

  • Commands that are displayed/suggested by the shell are case insensitive.
  • If an attribute group does not include any attributes, autocomplete does not display this group at all.
• Navigate the cursor within a command, by pressing:
  • Home key: Directs to the starting of the command
  • End key: Directs to the end of the command
• View the history of the commands that were run in the current session by pressing up and down arrow key.
• If an attribute value starts with double quotes but does not end with them, the value is still considered and the command runs successfully.
• Exit the Autocomplete mode, by entering Quit or Exit

For example:   

• Example 1: racadm>> <press tab>

  arp
  autoupdatescheduler
  clearasrscreen
  clearpending
  closessn
  clrraclog
  .
  .
  .
  .
  .
  .
  .
  vflashsd
  vflashpartition
  vmdisconnect
  cd
  quit

• Example 2: racadm>> get <press tab>

  get
  getled
  getniccfg
  getraclog
  getractime
  getsel
  getsensorinfo
  getssninfo
  getsvctag
  getsysinfo
  gettracelog
  getversion
  

• Example 3:

  racadm>> getl<press tab>

  racadm>> getled <press enter> or <racadm getled>
  LEDState: Not-Blinking 

• Example 4:

  racadm>> get bios.uefiBootSettings
  BIOS.UefiBootSettings
  BIOS.UefiBootSettings.UefiBootSeq
  BIOS.UefiBootSettings.UefiPxeIpVersion