Integrated Dell Remote Access Controller 9 RACADM CLI Guide

PDF

vflashsd

Table 1. Details of vflashsdThe following table provides details about the vflashsd subcommand:
vflashsd
Description Allows you to initialize or get the status of the vFlash SD card. The initialize operation removes all the existing partitions and resets the card. The status operation displays the status of the last operation performed on the card. To run this subcommand, you must have the Access Virtual Media privilege.
NOTE:After you restart the iDRAC, the status of the previous initialize operation is erased.
Synopsis
  • racadm vflashsd initialize
  • racadm vflashsd status
Input
  • Initialize— performs initialize operation on SD card.
  • Status — indicates to view the progress or status report of the initialize operation.
Output If initialization is in progress, the message Initialization of the vFlash SD Card is now in progress is displayed. If unsuccessful, appropriate error message is displayed. If the status of the last operation performed is successful, the message LastAction Progress Status=============Initialize SD Card 100 % Complete is displayed. If unsuccessful, appropriate error message is displayed.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\