Dell EMC PowerEdge T440 Installation and Service Manual

PDF

Installing the air shroud

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. If applicable, route the cables inside the system along the chassis wall and secure the cables by using the cable-securing bracket.

Steps

  1. Align the tabs on the air shroud with the securing slots on the chassis.
  2. Lower the air shroud into the chassis until it is firmly seated.
    NOTE When the cooling shroud is properly seated, the chassis intrusion-switch on the cooling shroud connects to the chassis intrusion-switch connector on the system board.
    Figure 1. Installing the air shroud
    This image shows how to install air shroud

Next steps

Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\