Dell EMC PowerEdge T440 Installation and Service Manual
Installing a 2.5-inch drive into a 3.5-inch drive adapter
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Remove the 3.5-inch drive adapter from the 3.5-inch hot swappable drive carrier.
Steps
- Align the screw holes on the 2.5-inch drive with the screw holes on the 3.5-inch drive adapter.
NOTE If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to install the drive.
- Using a Phillips #2 screwdriver, secure the 2.5-inch drive to the 3.5-inch drive adapter.
Figure 1. Installing a 2.5-inch drive into a 3.5-inch drive adapter 
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\