Dell EMC PowerEdge T440 Installation and Service Manual

PDF

Installing a drive blank

The procedure for installing 2.5-inch and 3.5-inch drive blanks is identical.

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.

  2. If installed, remove the front bezel.

CAUTION Mixing drive blanks from previous generations of PowerEdge servers is not supported.

Steps

Insert the drive blank into the drive slot, and push the blank until the release button clicks into place.
Figure 1. Installing a drive blank
This image shows how to install a drive blank

Next steps

If removed, install the bezel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\