Dell EMC PowerEdge T440 Installation and Service Manual

PDF

Installing caster wheels

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Place the system on its side on a flat, stable surface.
  3. If installed, remove the system feet.

Steps

  1. Align the two retention hooks on the rear wheel unit with the two slots on the base of the system, and insert the hooks into the slots.
  2. Push the rear wheel unit toward the back of the system and using a Phillips #2 screwdriver secure the unit in place using a single screw.
  3. Align the two retention hooks on the front wheel unit with the two slots on the base of the system, and insert the hooks into the slots.
  4. Push the front wheel unit toward the front of the system and using a Phillips #2 screwdriver secure the unit in place using a single screw.
    Figure 1. Installing caster wheels
    This image shows how to install caster wheels

Next steps

Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\