Dell EMC PowerEdge T440 Installation and Service Manual

PDF

Installing the control panel assembly

Prerequisites

Follow the safety guidelines listed in Safety instructions.

Steps

  1. Replace the blank information tag in the new control panel with the information tag retained from the old control panel.
    Figure 1. Installing the information tag
    This figure shows installing the information tag
    Figure 2. Installing the control panel assembly
    This image shows how to install the control panel assembly
  2. To install the information tag, push the information tag into the control-panel slot.
  3. Connect the control panel cable and the control panel USB cable to the control panel assembly.
  4. Align and insert the control panel into the control panel slot in the chassis.
  5. Secure the control panel to the chassis by using the screw.
  6. Connect the control panel cable and the control panel USB cable to the system board.

Next steps

  1. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\