Dell EMC PowerEdge T440 Installation and Service Manual

PDF

Installing the M.2 SSD module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. Remove the BOSS card.
    NOTE The procedure to remove the BOSS card is similar to the removing an expansion card.

Steps

  1. Connect the M.2 SSD module to the connector on the BOSS card.
  2. Place the retention strap on the M.2 SSD module, and tighten the screw to secure the module.
    Figure 1. Installing the M.2 SSD module
    This image shows how to install the M.2 SSD module.

Next steps

  1. Install the BOSS card.
    NOTE The procedure to install the BOSS card is similar to the removing an expansion card.
  2. Install the applicable air shroud.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\