Dell EMC PowerEdge T440 Installation and Service Manual

PDF

Installing the power interposer board

Prerequisites

CAUTION Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Follow the safety guidelines listed in Safety instructions.

Steps

  1. Align the slots on the power interposer board (PIB) with the hooks on the power supply unit (PSU) cage and slide the PIB until it snaps into place.
  2. Secure the PIB to the chassis by using the screw.
  3. Route the P3 power cable through the securing clip on the system board and connect power cable to the drive backplane.
    Figure 1. Installing the power interposer board
    This image shows installing the power interposer board

Next steps

  1. Install the cooling shroud.
  2. Install the PSUs or PSU blank.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\