AC power supply
units (PSUs) have an illuminated translucent handle that serves as
an indicator. The indicator shows whether power is present
or if a power fault has occurred. Figure 1. AC PSU status
indicator
AC PSU status
indicator/handle
Table 1. AC PSU status
indicator codesThis table describes the AC PSU status indicators
codes
Power indicator
codes
Condition
Green
A
valid power source is connected to the PSU, and the PSU is operational.
Blinking
amber
Indicates
a problem with the PSU.
Not
illuminated
Power
is not connected to the PSU.
Blinking
green
When
the firmware of the PSU is being updated, the PSU handle blinks green.
CAUTION Do not disconnect the power cord, or unplug the PSU when updating firmware.
If firmware update is interrupted, the PSUs do not function.
Blinking green and turns off
When hot-plugging a PSU, the PSU handle
blinks green five times at a rate of 4 Hz and powers off. It indicates
a PSU mismatch regarding efficiency, feature set, health status,
or supported voltage.
CAUTION If two
PSUs are installed, both the PSUs must have the same type of label;
for example, Extended Power Performance (EPP) label. Mixing PSUs from
previous generations of PowerEdge servers is not supported, even if
the PSUs have the same power rating. It results in a PSU mismatch
condition or failure to power on the system.
CAUTION When
correcting a PSU mismatch, replace only the PSU with the blinking
indicator. Swapping the PSU to make a matched pair can result in an
error condition and unexpected system shutdown. To change from a high
output configuration to a low output configuration or conversely,
you must turn off the system.
CAUTION AC PSUs
support both 240 V and 120 V input voltages except for
Titanium PSUs, which support only 240 V. When two identical PSUs receive
different input voltages, they can output different wattages, and
trigger a mismatch.
CAUTION If two
PSUs are used, they must be of the same type and have the same maximum
output power.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\