Dell EMC PowerEdge T440 Installation and Service Manual

PDF

Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. If installed, remove the front bezel.
  3. Remove the 3.5-inch drive carrier from the system.

Steps

  1. Using a Phillips #1 screwdriver, remove the screws from the rails on the drive carrier.
    NOTE If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to remove the drive.Torx screw image
  2. Lift the 3.5-inch drive adapter out of the 3.5-inch drive carrier.
    Figure 1. Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
    This image shows how to remove a drive adapter from a drive carrier

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\