Dell EMC PowerEdge T440 Installation and Service Manual

PDF

Removing a cabled drive

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the internal drive bay.

Steps

  1. Remove the four screws securing the drive to the internal drive bay.
  2. Remove the hard drive from the internal drive bay.
    Figure 1. Removing a cabled drive
    This image shows removing a cabled drive

Next steps

  1. Follow the procedure listed in After working inside your system.
  2. Install the internal drive bay into the chassis.
  3. If disconnected, reconnect the power and data cable(s) to the remaining drive(s) in the internal drive bay.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\