Dell EMC PowerEdge T440 Installation and Service Manual

PDF

Removing a expansion card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.
  4. Remove the expansion card holder.

Steps

  1. If installed, disconnect the data cables from the PERC card and/or the power cables from the GPU card.
  2. Press the expansion card latch and push down the latch to open it.
  3. Hold the expansion card by its edge, and pull the card up to remove it from the expansion card connector and the system.
  4. Install the filler brackets by performing the following steps:
    1. Align the slot on the filler bracket with the tab on the expansion card slot.
    2. Press the expansion card latch till the filler bracket locks into place.
    NOTE Filler brackets must be installed in empty expansion-card slots to maintain FCC certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
    Figure 1. Removing an expansion card
    This image shows how to remove an expansion card
    Figure 2. Installing the filler bracket
    This image shows how to install the filler bracket

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\