Dell EMC PowerEdge T440 Installation and Service Manual

PDF

Removing the MicroSD card

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system .

Steps

  1. Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate IDSDM/vFlash module, see the System board jumpers and connectors section.
  2. Hold the MicroSD card and remove it from the slot.
    Figure 1. Removing the MicroSD card
    Removing an Internal SD card
    NOTE Temporarily label each MicroSD card with its corresponding slot number after removal.

Next steps

  1. Follow the procedure listed in After working inside your system.
  2. Install a MicroSD card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\