Dell EMC PowerEdge T440 Installation and Service Manual

PDF

Removing the system cover

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Turn off the system and all attached peripherals.
  3. Disconnect the system from the electrical outlet and peripherals.
  4. If installed, remove the front bezel.
  5. Place the system on a flat, stable surface.

Steps

  1. Turn the latch release lock to the unlocked position.
  2. Press the cover release latch and remove the system cover.
    Figure 1. Removing the system cover
    This figure shows removing the system side cover.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\