Dell PERC13 and PERC12 User’s Guide PERC H975 Series and PERC H965 Series cards

PDF

Install or update a RPM driver package using the KMOD support

Prerequisites

NOTE:This procedure is applicable for RHEL 8.0 and later versions.

About this task

To install the RPM package with KMOD support, do the following:

Steps

  1. Expand tarball driver release package.
  2. Install the driver package by running the command: rpm –ihv kmod-mpi3mr-<version>.rpm.
    NOTE:Use rpm -Uvh <package name> when upgrading an existing package.
  3. If the previous device driver is in use, you must restart the system for the updated driver to take effect.
  4. Verify the loaded driver version by running the following command: modinfo mpi3mr.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\