Dell PERC13 and PERC12 User’s Guide PERC H975 Series and PERC H965 Series cards

PDF

Install the driver on which Windows is already installed

About this task

Perform the following steps to configure the driver for the controller on which Windows is already installed:

Steps

  1. Power off the system.
  2. Install the new SAS controller in the system.
    For instructions on installing the controller in the system, see Install and remove a PERC13 and PERC12 card.
  3. Power on the system.
    The Found New Hardware Wizard screen displays the detected hardware device.
  4. Click Next.
  5. On the Locate device driver screen, select Search for a suitable driver for my device and click Next.
  6. Browse and select the drivers on the Locate Driver Files screen.
  7. Click Next.
  8. Click Finish.
  9. Reboot the system when prompted.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\