Dell PERC13 and PERC12 User’s Guide PERC H975 Series and PERC H965 Series cards

PDF

Set a drive as the first device to operating system

About this task

The First Device feature is available only on Linux-based servers. Using the First Device feature, you can select the order in which the PD or VD must be presented to the operating system. You can also select the PD or VD on which you can install the operating system Do the following:

Steps

  1. Navigate to the PERC Configuration Utility.
  2. Click Main Menu > Controller Management > Advanced Controller Properties.
  3. In the Controller Properties section, from the First Device drop-down menu, select the PD or VD that must be set as the first device.
  4. Click Apply Changes.
    The selected Physical Device or Virtual Drive is set as the first device.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\