Dell PERC13 and PERC12 User’s Guide PERC H975 Series and PERC H965 Series cards

PDF

Set the patrol read mode

Steps

  1. Navigate to the PERC Configuration Utility.
  2. Click Main Menu > Controller Management > Advanced Controller Properties.
  3. Click Patrol Read.
    The following options are displayed:
    • Start—Starts patrol-read for the selected controller.
    • Suspend—Suspends the ongoing patrol-read operation on the controller.
    • Resume—Resumes the suspended patrol-read operation.
    • Stop—Stops patrol-read for the selected controller.
    • Rate—Indicates the percentage of system resources that are dedicated to perform the patrol-read operation.
  4. To enable or disable patrol-read and to correct unconfigured areas on the hard drive, click Correct Unconfigured Areas.
  5. Click Apply Changes.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\