- Notes, cautions, and warnings
- About this document
- Dell EMC PowerEdge C4140 system overview
- Initial system setup and configuration
- PowerEdge C4140 installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Air shroud
- Cooling fans
- Hard drives
- Intrusion switch
- System memory
- Expansion cards and expansion card risers
- Processor and heat sink
- Network daughter card
- System battery
- Optional internal USB memory key
- Graphics processing unit
- PCIe Graphics processing unit
- GPU installation guidelines
- Removing a GPU riser cable from the GPU switch board
- Removing a GPU
- Removing a GPU riser cable board
- Removing the GPU brackets from the GPUs removed from your system
- Removing the GPU brackets from the replacement GPUs
- Removing the GPU switch board
- Installing the optional GPU switch board
- Installing the custom GPU brackets on the replacement GPUs
- Installing the GPU brackets on the GPUs removed from your system
- Installing a GPU riser cable board
- Installing a GPU
- Installing a GPU riser cable on the GPU switch board
- GPU cabling diagrams
- SXM2 Graphics processing unit
- Power supply units
- System board
- Trusted Platform Module
- Control panel
- Jumpers and connectors
- System diagnostics
- Getting help
- Documentation resources
Dell EMC PowerEdge C4140 Installation and Service Manual
Expansion cards and expansion card risers
NOTE A System Event Log
(SEL) event is logged if an expansion card riser is not supported
or missing. It does not prevent your system from turning on. However,
if a F1/F2 pause occurs with an error message, see Troubleshooting expansion cards section in the Dell EMC PowerEdge Servers Troubleshooting Guide at www.dell.com/poweredgemanuals.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\