Dell PowerEdge FD332 Owner's Manual

PDF

Split single host mapping configuration

In the split single host mapping configuration, dual controllers inside a storage sled map to a single compute sled.
The following enclosure configurations support split single host mapping.
  • Four-bay chassis with two compute sleds—dual controllers inside a storage sled map to a half-width compute sled.
  • Four-bay chassis with one compute sled—dual controllers inside each storage sled map to the single half-width compute sled.
  • Three-bay chassis with one compute sled—dual controllers inside each storage sled map to the single full-width compute sled.
  • NOTE: PowerEdge FX2s supports multiple split single host mapping configurations. You must select the desired configuration based on your intended usage.
Figure 1. Split single host mapping configuration—four-bay chassis
Figure 2. Split single host mapping configuration—four-bay chassis (one compute sled)
Figure 3. Split single host mapping configuration—three-bay chassis

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\