Dell PowerEdge FD332 Owner's Manual

PDF

Terms used in this document

The following table describes the terms used in this document.
Term Description
Enclosure or chassis Refers to the PowerEdge FX2s enclosure.
  • NOTE: PowerEdge FD332 is not supported on the PowerEdge FX2 enclosure.
Three-bay chassis Refers to the PowerEdge FX2s enclosure configuration that supports one full-width and two half-width sleds.
Four-bay chassis Refers to the PowerEdge FX2s enclosure configuration that supports four half-width sleds.
Six-bay chassis Refers to the PowerEdge FX2s enclosure configuration that supports four quarter-width sleds and two half-width sleds.
Storage sled or system Refers to PowerEdge FD332.
Compute sled Refers to the half-width, quarter-width, or full-width sleds, to which the storage sled(s) may be mapped.
  • NOTE: The storage sled is not supported with the PowerEdge FM120x4 half-width compute sled.
Hot swap A component is considered hot swap if it can be removed or installed while the sled is powered on.
Drive drawer Refers to the hard drive/SSD drawer that can support up to 16 hot swap hard drives/SSDs.
PowerEdge RAID Controller (PERC) Refers to the storage adapter(s) on the storage controller module.
PowerEdge HBA Controller (HBA) Refers to the storage adapter(s) on the storage controller module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\