Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge M620 Systems Owner's Manual

Replacing The Internal USB Key

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  • CAUTION: To avoid interference with other components in the blade, the maximum allowable dimensions of the USB key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
  1. Remove the blade from the enclosure.
  2. Open the blade.
  3. Locate the USB connector / USB key.
  4. If installed, remove the USB key.
  5. Insert the new USB memory key into the USB connector.
  6. Close the blade.
  7. Install the blade in the enclosure.
  8. Enter the System Setup and verify that the USB key is detected by the system.
    Figure 1. Replacing the USB Memory Key The figure shows replacing the USB memory key.
    1. USB memory key connector
    2. USB memory key

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\