- Notes, cautions, and warnings
- Dell PowerEdge M630 overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Options to manage the pre-operating system applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- Viewing System BIOS
- System BIOS Settings details
- Boot Settings
- Network Settings
- System Security
- System Information
- Memory Settings
- Processor Settings
- SATA Settings
- Integrated Devices
- Serial Communication
- System Profile Settings
- Miscellaneous Settings
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Installing and removing blade components
- Safety instructions
- Recommended tools
- Removing and installing a blade
- System cover
- Inside the blade
- Cooling shroud
- Processor blank and DIMM blank
- System memory
- I/O module mezzanine cards
- Internal dual SD module (optional)
- rSPI card (optional)
- SD vFlash card
- Network Daughter Card
- Processors
- Hard drives or SSDs
- Hard drive or SSD bay numbering
- Hard drive or SSD installation guidelines
- Removing a hard drive or SSD
- Installing a hard drive or SSD
- Removing a hard drive or SSD blank
- Installing a hard drive or SSD blank
- Shutdown procedure for servicing a hard drive or SSD
- Configuring the boot drive
- Removing a 2.5-inch hard drive or SSD from a 2.5-inch hard drive or SSD carrier
- Installing a 2.5-inch hard drive or SSD in a 2.5-inch hard-drive or SSD carrier
- Removing a 1.8-inch SSD from a 1.8-inch SSD carrier
- Installing a 1.8-inch SSD in a 1.8-inch SSD carrier
- Removing the hard drive or SSD cage
- Installing the hard drive or SSD cage
- Hard drive or SSD backplane
- System board
- Trusted Platform Module
- System battery
- Storage controller card or PCIe extender card
- Using system diagnostics
- Jumpers and connectors
- Troubleshooting your system
- Getting help
Dell PowerEdge M630 Owner's Manual
Options to set up iDRAC IP address
You must configure
the initial network settings based on your network infrastructure
to enable the communication to and from iDRAC. You can set up the IP address by using one of the following
interfaces:
- Interfaces
- Document/Section
- iDRAC Settings utility
- See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals
- Dell Deployment Toolkit
- See Dell Deployment Toolkit User’s Guide at Dell.com/openmanagemanuals
- Dell Lifecycle Controller
- See Dell Lifecycle Controller User’s Guide at Dell.com/idracmanuals
- CMC Web interface
- See Dell Chassis Management Controller Firmware User’s Guide at Dell.com/esmmanuals
You must use the default iDRAC IP address 192.168.0.120 to configure the initial network settings, including setting up DHCP or a static IP for iDRAC.
NOTE: To access iDRAC, ensure that you install the iDRAC port card or connect
the network cable to the Ethernet connector 1 on the system board.
NOTE: Ensure that you change the default user name and password after setting
up the iDRAC IP address.
NOTE: In case of blade servers, you can
configure the network setting by using the Chassis LCD panel only
during initial configuration of CMC. After the chassis is deployed,
you cannot reconfigure iDRAC by using the Chassis LCD panel.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\