Dell EMC PowerEdge MX840c Installation and Service Manual

PDF

After working inside your sled

Prerequisites

Follow the safety guidelines listed in the Safety instructions section.

Steps

  1. Install the sled cover.
  2. If installed, remove the I/O connector cover on the sled.
    CAUTION To prevent damage to the I/O connectors, do not touch the connectors or the connector pins.
  3. Install the sled into the enclosure.
  4. Power on the sled.
    NOTE The sled iDRAC has to completely initialize first for the sled to power on.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\