Dell EMC PowerEdge MX840c Installation and Service Manual

PDF

Installing the M.2 BOSS module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your sled.

Steps

  1. Align the M.2 BOSS module connector with the connector and guide on the system board.
  2. Press on the M.2 BOSS module until it is firmly seated on the system board.
    Figure 1. Installing the M.2 BOSS module
    This image shows how to install the M.2 BOSS module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\