Dell EMC PowerEdge MX840c Installation and Service Manual

PDF

Installing a mini Mezzanine card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your sled section.

Steps

  1. Remove the connector cap on the I/O connector of the mini Mezzanine card.
  2. Lift the blue pull tag to raise the lever up of the mini Mezzanine card.
  3. Align the mini Mezzanine card connector, guides, and guide slots with the connector, guide, guide slots on the sled or PEM.
  4. Lower and press the mini Mezzanine card until firmly seated.
    Figure 1. Installing the mini Mezzanine card
    This image shows how to install the mini Mezzanine card.
    NOTE The PowerEdge MX840c sled supports HBA330 MMZ and Fiber channel MMZ which are installed in the mini Mezzanine card slot.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\