Dell EMC PowerEdge MX840c Installation and Service Manual
Installing a drive carrier
Prerequisites
CAUTION Before attempting
to remove or install a drive while the system is running, see
the documentation for the storage controller card to ensure that the
host adapter is configured correctly to support drive removal
and insertion.
CAUTION Mixing drive carriers
from previous generations of PowerEdge servers is not supported.
CAUTION Combining SAS and SATA drives in the same RAID
volume is not supported.
CAUTION When installing a
drive, ensure that the adjacent drives are fully installed. Inserting
a drive carrier and attempting to lock its handle next to a partially
installed carrier can damage the partially installed carrier's shield
spring and make it unusable.
CAUTION To prevent data loss, ensure that your operating system supports
hot-swap drive installation. See the documentation supplied with your
operating system.
CAUTION When a replacement hot swappable drive is installed and the system is powered on, the drive automatically
begins to rebuild. Ensure that the replacement drive is blank or contains
data that you wish to overwrite. Any data on the replacement drive
is immediately lost after the drive is installed.
- Follow the safety guidelines listed in the Safety instructions section.
- If installed, remove the drive blank.
Steps
- Press the release button on the front of the drive carrier to open the release handle.
- Insert the drive carrier into the drive slot and slide until the drive carrier connects with the backplane.
- Close the release handle of the drive carrier to lock the drive in place.
Figure 1. Installing a drive carrier 
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\