Dell EMC PowerEdge MX840c Installation and Service Manual

PDF

Installing a drive into the drive carrier

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
CAUTION Mixing drive carriers from other generations of PowerEdge servers is not supported.
NOTE When installing a drive into the drive carrier, ensure that the screws are torqued to 4 in-lbs.

Steps

  1. Place the drive into the drive carrier with the connector end of the drive towards the back of the carrier.
  2. Align the screw holes on the drive with the screws holes on the drive carrier.
  3. Using a Phillips #1 screwdriver, secure the drive to the drive carrier with screws.
    Figure 1. Installing a drive into the drive carrier
    This image shows how to install a drive into the drive carrier.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\