Dell EMC PowerEdge MX840c Installation and Service Manual

PDF

Installing the air shroud on the system board

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your sled section.

Steps

  1. Align the slots on the air shroud with the guide pins on the system board.
  2. Lower the air shroud into the sled until it is firmly seated.
    Figure 1. Installing the air shroud on the system board
    This image shows how to install the air shroud on the system board.

Next steps

  1. Install the PEM.
  2. Follow the procedure listed in the After working inside your sled section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\