Dell EMC PowerEdge MX840c Installation and Service Manual

PDF

Installing the Mezzanine card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your sled section.

Steps

  1. Align the connector on the Mezzanine card with the connector on the system board.
  2. Place the Mezzanine card on the connector, and press the blue push point until firmly seated.
  3. Using the Phillips #2 screwdriver, tighten the captive screw on the Mezzanine card.
    Figure 1. Installing the Mezzanine card on the system board
    This image shows how to install the Mezzanine card on the system board.
    Figure 2. Installing the Mezzanine card on the PEM
    This image shows how to install the Mezzanine card on the PEM.

Next steps

  1. After installing the Mezzanine card on the system board, install the PEM.
  2. Follow the procedure listed in the After working inside your sled section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\