Dell EMC PowerEdge MX840c Installation and Service Manual

PDF

Installing the PERC card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your sled section.

Steps

  1. Lift the blue pull tag to raise the lever up on the PERC card.
  2. Align the connector and guide slots on the PERC card with the connector and guides on the sled.
  3. Lower and press the PERC card to firmly seat on the system board connector and close the lever on the PERC card.
    Figure 1. Installing the PERC card
    This image shows how to install the PERC card.

Next steps

  1. Connect the cable to the PERC card.
  2. Install the PEM.
  3. Follow the procedure listed in the After working inside your sled section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\