Dell EMC PowerEdge MX840c Installation and Service Manual

PDF

Installing the sled into the enclosure

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.

Steps

  1. Remove the I/O connector cover from the I/O connector(s) and store for future use.
    CAUTION To prevent damage to the I/O connectors, do not touch the connectors or the connector pins.
    Figure 1. Removing the I/O connector cover from the sled
    This image shows how to remove the I/O connector cover from the sled.
    NOTE The color of the I/O connector cover may differ.
  2. Press the blue lever button on the sled to release the lever.
  3. Holding the sled with two hands, align the sled with the bay in the enclosure and slide the sled into the enclosure until firmly seated.
  4. Rotate the lever up until it clicks into place and secures the sled in the enclosure.
    Figure 2. Installing the sled into the enclosure
    This image shows how to install the sled into the enclosure.

Next steps

  1. Power on the sled.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\