Dell EMC PowerEdge MX840c Installation and Service Manual

PDF

Removing a MicroSD card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your sled section.
  3. Remove the PEM.
  4. Remove the IDSDM module.

Steps

  1. Locate the MicroSD card slot on the IDSDM module.
  2. Press the card to partially release from the slot.
  3. Hold the MicroSD card, and remove it from the slot.
    NOTE Temporarily label each MicroSD card with the corresponding slot number after removal.
    Figure 1. Removing a MicroSD card
    This image shows how to remove a MicroSD card.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\