Dell EMC PowerEdge MX840c Installation and Service Manual

PDF

Removing a mini Mezzanine card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside a sled section.
  3. To remove the mini Mezzanine card from the system board, remove the PEM.
  4. Remove the air shroud from the system board.

Steps

  1. Lift the blue pull tag to raise the lever up on the mini Mezzanine card.
  2. Hold the lever and the edge of the mini Mezzanine card to lift the mini Mezzanine card away from the sled or PEM.
    Figure 1. Removing the mini Mezzanine card
    This image shows how to remove the mini Mezzanine card.
  3. Install the connector cap on the I/O connector of the mini Mezzanine card.
    NOTE The PowerEdge MX840c sled supports HBA330 MMZ and Fiber channel MMZ which are installed in the mini Mezzanine card slot.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\