Dell EMC PowerEdge MX840c Installation and Service Manual

PDF

Removing the control panel

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your sled section.
  3. Remove the PEM.
  4. Remove all the drives.
  5. Remove the backplane.
  6. Remove the drive cage.
  7. Remove the BBU module.

Steps

  1. Pull the blue strap to disconnect the control panel cable connected to the system board.
  2. Using a Phillips #1 screwdriver, remove the screws that secure the control panel to the sled.
  3. Lift the control panel out of the sled.
    Figure 1. Removing the control panel
    This image shows how to remove the control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\