Dell EMC PowerEdge MX840c Installation and Service Manual

PDF

Removing the M.2 BOSS module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your sled.
  3. Remove the PEM.
  4. Remove the air shroud from the system board.

Steps

Hold the blue pull tag, and lift the M.2 BOSS module away from the sled.
Figure 1. Removing the M.2 BOSS module
This image shows how to remove the M.2 BOSS module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\