Dell EMC PowerEdge MX840c Installation and Service Manual

PDF

Removing the sled from the enclosure

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Power off the sled.

Steps

  1. Press the blue lever button on the sled to release the lever.
  2. Holding the release lever, slide the sled out of the enclosure.
    Figure 1. Removing the sled from the enclosure
    This image shows how to remove the sled from the enclosure.
    NOTE Support the sled with both hands while sliding it out of the enclosure.
  3. Install the I/O connector cover on the sled.
    CAUTION To protect the I/O connector pins, install the I/O connector cover every time a sled is removed from the enclosure.
    Figure 2. Installing the I/O connector cover on the sled
    This image shows how to install the I/O connector cover on the sled.
    CAUTION If you are permanently removing the sled, install a blank. Operating the enclosure for extended periods of time without a blank installed can cause the enclosure to overheat.
    NOTE The color of the I/O connector cover may differ.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\