Dell EMC PowerEdge MX840c Installation and Service Manual

PDF

Setting up your sled

Complete the following steps to set up your sled:

Steps

  1. Unpack the sled.
  2. Remove the I/O connector cover from the sled connectors.
    CAUTION While installing the sled, ensure that it is properly aligned with the slot on the enclosure to prevent damage to the sled connectors.
  3. Install the sled in the enclosure.
  4. Power on the enclosure.
    NOTE Wait for the chassis to initialize before you press the power button.
  5. Press the power button on the sled.
    Alternatively, you can also power on the sled by using:

    • The sled iDRAC. For more information, see the Log in to iDRAC section.

    • Open Manage Enterprise modular (OME-modular), after the sled iDRAC is configured on the OME. For more information, see the OME-modular User’s Guide at www.dell.com/openmanagemanuals.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\