Dell PowerEdge RAID Controller S140 User’s Guide

PDF

Controller mode is set incorrectly at system setup

  1. In the system startup, when the Dell Power-On Self-Test (POST) screen is displayed, press F2 to enter the system BIOS screen.
  2. Scroll to SATA Settings. Press Enter and ensure that the SATA Controller is set to RAID mode.
    WARNING:While switching from RAID Mode to ATA Mode or AHCI Mode, there may be data loss.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\