Dell PowerEdge RAID Controller S140 User’s Guide

PDF

Converting a physical disk to a Non-RAID disk

  1. Enter the Dell PERC S140 Configuration Utility. See Entering the DELL PERC S140 Configuration Utility.
  2. Click Controller Management > Convert to Non-RAID Disk.
  3. Select the interface type.
  4. Select the physical disks. Click Check All to select all the disks available.
  5. Click Apply Changes.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\