Dell PowerEdge RAID Controller S140 User’s Guide

PDF

Unassign a global hot spare

NOTE:Unassigning a hotspare may place the data at risk in the event of a disk failure.
  1. Enter the Dell PERC S140 Configuration Utility. See Entering the DELL PERC S140 Configuration Utility.
  2. Click Physical Disk Management > Select Physical Disk Operations.
  3. Select a global hot spare disk from the drop-down menu.
  4. Click the link Unassign Hot Spare.
    Confirmation screen appears.
  5. Click Yes to confirm.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\